===== Ignite Setup =====

This page is for information regarding the setup, configuration and installation of Ignite Radios (millimeter wave) 

** IMPORTANT POE INFORMATION **

Each Ignite Device comes with it's own POE type. MAKE SURE YOU USE THE CORRECT POE AS THE INCORRECT VOLTAGE WILL DAMAGE EQUIPMENT.

  * MetroLinq LW FCC and MetroLinq 60-35 use 24 volt 1 amp POE's
  * MetroLinq 2.5 60-35 use 48 volt .55 amp POE's
  * The OMNI Sectors use 48 volt 1.35 amp POE's

**WHEN IN DOUBT CHECK THE SPEC SHEET** 

==== Configuration ====

The default IP address of a brand new radio is http://192.168.1.20

To reach the radio, do the following:
Open the Control Panel- Network and Sharing Center- Change Adapter Settings- choose the Ethernet connection you are using, and select properties. Change the IP under the IPv4 selection. 

  - Set your IP address to 192.168.1.100 with a subnet of 255.255.255.0 (figure 1)
  - Open a command prompt and run the command (without quotes): “ping 192.168.1.20 -t”
  - Confirm you are able to ping the radio

{{tech:igniteconfig1.jpg|}}

Log into the radio:

  - Open a browser in Private Browsing / Incognito mode
  - type 192.168.1.20 in the browser
  - username: **root** password: **admin123**

{{tech:igniteconfig2.jpg|}}

**You will be asked if this device is managed by the cloud. Click NO**


==== Upgrade the Firmware on the Unit BEFORE Configuration ====

  - Click system
  - Click maintenance
  - Click Upgrade
  - Click "change" and select the firmware version (currently 2.4.2-4179)
  - Click Upgrade
  - Click on Proceed when the next window appears. This will take 2-4 minutes

{{tech:igniteconfig4.jpg|}}

==== - Configure the Radio Settings *this is done onsite after mounted on the roof and dialed in* ====

When the device responds to pings again, log back into the radio. **THESE SETTINGS MUST BE EXACT OR THE RADIO WILL NOT CONNECT TO A SITE** You will also risk the wrath of the field technician doing the install. 

  - Click on Wireless. Select the 60 GHz radio. The 5 GHz radio will not be used by us - DO NOT turn it on
  - Mode: Client
  - Channel: Auto
  - Enter the AP Key - **PCjUWKwCpe43kvsV**
  - Turn the transmit power to the maximum
  - Click Save
  - Click Apply

{{tech:igniteconfig5.jpg|}}

NEED TO ADD INFO ON LATCHING TO AP

==== Set the VLAN Settings ====

**This it the final step, be absolutely certain every setting before is correct. Once a VLAN is set, you will not be able to log back into it easily**

**Select Network**

  - Turn "Mgmt VLAN" on
  - Set "Mgmt VLAN ID" to **202**
  - Click Save and apply the settings

{{tech:igniteconfig8.jpg|}}


If done correctly, your ping will no longer work but the radio is ready for installation