Intellipop Wiki

This page is for the configuration of a UBNT radio from a factory defaulted status.

The default IP address of a brand new radio is http:/192.168.1.20

Note: All of these radios in use are used, you may need to factory default the radio by using a paperclip to push the factory default button on the radio. The factory default button is next to the Ethernet port on the radio and will need to be removed from the antenna for access.

To reach the radio, do the following:

• Set your IP address to 192.168.1.100 with a subnet of 255.255.255.0 (figure 1)
• open a command prompt and run the command (without quotes): “ping 169.254.1.1 -t”
• Confirm you are able to ping the radio

Log into the radio by opening a browser and going to http://192.168.1.20

• username: ubnt
• password: ubnt
• Country: United States
• Click on their Terms of Service checkbox

Important things to remember about UBNT installations:

1. Internal IP addresses are handed out based on ACCESS POINT - NOT THE TOWER
2. The public IP address are also handed on based on ACCESS POINT
3. Some AP's do not have passwords. See Ubnt AP Passwords for more information

For these next steps it is easiest to have 2 tabs open to go back and forth from.

1. Open the customers account
2. Click on “more” next to the UBNT equipment on the account
3. Take note of the IP address settings, you will need to set this all manually

Click on “more”

1. Once you have this the equipment tab open in Powercode, switch back to the UBNT device
2. Click on the “wireless” tab
3. Click on the “WDS (Transparent Bridge Mode) checkbox
4. Enter the name of the SSID CASE SENSATIVE
5. Enter the security code ONLY IF THE AP HAS A PASSWORD check the Ubnt AP Passwords page
6. Click on change but DO NOT apply yet
7. After you click change, select the “NETWORK” tab

1. Copy and paste the IP settings from Powercode into the UBNT device
2. Management IP Address: Static
3. Enter the IP Address
4. Netmask (AKA Subnet)
5. Gateway IP
6. Both DNS servers
7. Click on Change but DO NOT APPLY YET
8. Select the Services Tab

1. Enable the SNMP Agent by checking the box
2. SNMP Community String: 9gRMEFTWY6AIQ8
3. Contact: support@intellipop.co
4. Location: Tower name
5. Click on Change but do not apply yet
6. Click on System

• Click on the key icon, this will open up the password change option
• Current password should be ubnt
• New password: EIxRM9IXG2okqL
• Verify New Password: EIxRM9IXG2okqL
• Click on Change
• Now you can Apply
• This will make the radio only accessible from the IP address you assigned to it, so be absolutely sure all settings are correct